Sherman CUTTER 130CNC plasma cutter, 125 A, 400 V, up to 45 mm

Sherman CUTTER 130CNC is an IGBT plasma cutting power source intended for integration into automated CNC cutting systems. It cuts steel, aluminium and copper sheet and other electrically conductive metal workpieces with settings selected for the material and thickness.

Cutting current adjusts over 30–125 A and the supply is three-phase 3 × 400 V, 50 Hz. The rated duty cycle is 125 A / 60% and the maximum stated cutting thickness is 45 mm. This store listing specifies an IPTM-120 machine torch with a 12 m lead.

Integration into a CNC system

The power source is intended for automated plasma cutting with a machine torch. Before connection, check the control interface of the individual version and its compatibility with the CNC controller using the machine instructions. A cutting table and CNC controller are not listed as included with this product.

NO-HF ignition and EMC filtering

The pilot arc uses a NO-HF starting system without high-frequency ignition. Reinforced EMC filtering is intended to reduce electromagnetic interference affecting CNC control and drive systems. Follow the requirements of the individual equipment when integrating and routing cables.

Compressed-air supply

The store catalogue lists an air requirement of 500 l/min. Supply clean, dry compressed air and select the compressor by delivered flow at working pressure. Check the required pressure and torch airflow in the instructions for the supplied torch version. Tank capacity alone does not establish compressor suitability.

Cutting limit and duty cycle

45 mm is the maximum stated limit under optimum carbon-steel cutting conditions. Assess required cut quality and speed on a sample; this maximum alone does not define a quality-cut thickness for every metal. The 125 A / 60% duty cycle represents 6 minutes of cutting and 4 minutes of cooling within a 10-minute cycle under the manufacturer’s specified conditions.

Supplied equipment and torch version

• Sherman CUTTER 130CNC plasma cutting power source
• IPTM-120 machine plasma torch with 12 m lead
• Return cable
• Hand-held welding shield
• Hammer with brush

The list follows the existing store package. The manufacturer’s current offer specifies an IPXM-102 torch with a 9 m lead, so confirm the actual supplied torch version and lead length before ordering. Manual cutting requires a separate compatible hand torch.