Product code: YT-99700
Available quantity Available
| Brand | YATO |
|---|---|
| Model | YT-99700 |
| Maximum output | 2 kW |
| Supply voltage | 220–240 V |
| Supply phases | Single-phase |
| Operating settings | 25 / 1000 / 2000 W |
| Frequency | 50 Hz |
| Airflow | 180 m³/h |
| Ingress protection | IPX0 |
| Dimensions | 210 × 160 × 217 mm |
| Weight | 1.5 kg |
| Cable length | 1.3 m |
| Overheat protection | Yes |
| Auto-reset thermostat parameter | 68 °C |
| Manufacturer indicative maximum area | 20 m² |
| Heating element | PTC ceramic |
| Manufacturer: | YATO |
YATO YT-99700 is a 2 kW electric fan heater for workshops, garages and other work areas. The fan distributes heated air and operation requires a 220–240 V electrical supply.
Heat is produced electrically, without diesel or gas and without fuel combustion products. Choose a model according to room volume, insulation and heat loss.
Settings are 25 / 1000 / 2000 W. The lowest figure is fan operation without active heating; the other two provide partial and maximum heating output.
A PTC ceramic element heats the passing airflow. Overheat protection and an auto-reset thermostat are fitted. The thermostat temperature in the table is a technical protection parameter, not a room temperature setting.
The manufacturer’s heated-area figure is indicative. The heater can assist drying, but moisture must be removed by ventilation or a dehumidifier.
The supply circuit must match 220–240 V and the appliance load. Select connectors and cables according to the rating plate and manual. Keep air openings clear, observe specified clearances and prevent unsuitable contact with water. Use this IPX0 model in a dry environment.
The heater is supplied with the stated power cable. Additional ducts, installation kits or other accessories are not specified.
There are no reviews for this product!