PULI PL1820 Wheel Balancer, 65 kg, 220 V

The PULI PL1820 is a wheel balancer for automotive wheels, used to identify imbalance and determine the balancing weights required for correction. It accommodates wheels weighing up to 65 kg and rims with a diameter of 10–22″.

The measuring gauge automatically enters the distance to the rim and the rim diameter. Self-calibration and diagnostic functions support machine preparation and condition checks.

Measurement and balancing workflow

There are 5 balancing modes to select from. The specified measuring cycle is 8 seconds. Select a mode suited to the rim and to the way the balancing weights are attached.

Wheel and rim selection

Check the complete wheel weight as well as the rim diameter and width. The rim width range is 1.5–20″. Correct centring requires mounting components matched to the wheel centre bore; diameter alone does not establish compatibility.

Preparation for use

Remove old balancing weights, clean the mounting surfaces and centre the wheel accurately before measurement. Perform self-calibration as directed in the machine instructions. Run a further measurement after applying the correction weights.

Power supply and accessories

The version offered here is specified for 220 V, 50 Hz power. Check the actual machine rating plate and connection requirements before preparing the work area. Confirm the supplied centring cones, adapters and other accessories against the wheels to be serviced.