AG-60 / SG-55 plasma torch equipment is used with compatible air plasma cutting machines. This Irankistai.lt category lists an AG-60 / SG-55 torch with hose assembly and replacement consumables, including CUT-50 nozzle, electrode and accessory kits. When selecting a torch or spare parts, check the exact model, connectors, dimensions and manufacturer compatibility information.
The catalogue lists the AG-SG60 plasma torch with an 8 m hose assembly and a 2-pin control plug. Before replacing an existing torch, compare its control connector, torch fitting, air supply and machine requirements. A matching torch designation alone does not guarantee compatibility with every CUT-series plasma cutting machine.
Plasma cutting consumables are subject to wear during normal operation. Two different replacement kits are listed for AG-60 / SG-55 and CUT-50 systems:
Select a kit based on the exact torch version, condition of existing consumables and intended workload. Confirm the design, fitting and compatibility of each part before purchase.
These designations may appear across different torch and plasma cutter product ranges. The Irankistai.lt PM-CUT50_1 and PM-CUT50 kits are listed for AG-60 / SG-55 and CUT-50 systems. However, the model name alone does not establish compatibility with every similarly labelled machine. Compare original part numbers, dimensions, connectors and manufacturer documentation.
Worn electrodes and cutting nozzles can cause unstable arcs, uneven cuts, increased dross and reduced cutting quality. Inspect consumables using the manufacturer's wear criteria. Before replacing components, switch off the machine, disconnect power and follow its safety instructions.
Regularly inspect electrodes, nozzles, retaining parts, cables and the hose assembly. Avoid sharp hose bends. Use clean, dry compressed air at the correct pressure and replace components according to manufacturer instructions. During cutting, wear suitable eye and face protection, gloves and protective clothing, and provide effective fume extraction.
These designations are used together in the catalogue, but compatibility between versions from different manufacturers should not be assumed. Check connectors and consumable dimensions.
The catalogue lists an 8 m hose assembly.
The catalogue specifies a 2-pin control plug. Connector shape and electrical compatibility must be verified separately.
PM-CUT50_1 includes one ceramic cap, one cutting nozzle and one electrode. PM-CUT50 includes one ceramic cap, five cutting nozzles, five electrodes and one standoff tip.
Not necessarily. Check exact part numbers, construction and manufacturer compatibility information.
The CUT60LNS set is described for the PULI CUT-60L system. Its compatibility with AG-60 / SG-55 has not been confirmed, so it should not be treated as a direct replacement without further verification.