A-101 plasma torch equipment and consumables are used with compatible air plasma cutting systems. This Irankistai.lt category includes A-101 torches, cutting nozzles, electrodes, gas diffusers and protective caps. Some catalogue components are specified for both A-101 and A-141 torch systems, but exact compatibility must be verified against each product's technical specifications.
According to the catalogue specifications for CUT-A101-6, the A-101 torch has a 6 m hose package, a listed cutting current of 100 A, a duty cycle of 100 A / 60%, operating air pressure of 4.5–5.0 bar and an airflow requirement of 180 l/min. These figures refer to this particular catalogue product and should not be assumed to apply to every A-101-type torch.
Check nozzle orifice diameter, physical design, torch compatibility and the manufacturer's operating recommendations. The A-101 / A-141 nozzle sizes listed in this category are 1.1 mm, 1.4 mm, 1.7 mm and 1.9 mm. Orifice diameter alone does not establish the correct cutting current; consult the torch and machine documentation.
Some catalogue nozzles, electrodes and diffusers are described as suitable for A-101 / A-141 systems. This does not mean that all parts across these torch families are interchangeable. Compare exact part numbers, dimensions, connections and manufacturer compatibility information before ordering.
Worn electrodes and nozzles can cause unstable arcs, uneven cuts, increased dross and reduced cutting quality. Inspect consumables according to manufacturer instructions and replace damaged or excessively worn components. Correct air pressure, clean dry air and suitable cutting parameters can help reduce premature wear.
Before replacing torch parts, switch off the equipment, disconnect the power supply and follow the manufacturer's safety procedures. During cutting, use suitable eye and face protection, gloves, protective clothing and effective fume extraction. Check the compressed-air system, cables and connections.
Some catalogue nozzles are listed for both systems, but each part must be checked by its code and technical dimensions.
The catalogue includes A-101 / A-141 cutting nozzles with 1.1 mm, 1.4 mm, 1.7 mm and 1.9 mm orifices.
The listed CUT-A101-6 model has a 6 m hose package. Other models may differ.
The catalogue lists 4.5–5.0 bar operating pressure for CUT-A101-6. Requirements for other torches may differ.
Only when its construction and dimensions are confirmed compatible with the torch. Several different diffuser designs are listed.
Follow the manufacturer's wear criteria. Unstable arcs or deteriorating cutting quality may indicate that the electrode and nozzle need inspection.
Sorry, but there are no products to list in this category.