SPARTUS EasyMIG 217 Dual Pulse MIG/MAG welder, 200 A, 230 V

SPARTUS EasyMIG 217 Dual Pulse is an inverter welder with synergic MIG/MAG control, single pulse and double pulse. Powered by a single-phase 230 V supply, it also offers TIG DC Lift and MMA for workshop repairs, assembly and fabrication tasks.

The LCD displays parameters and graphically indicates the recommended material thickness for the selected current. Synergic programs simplify setup, while manual operation and parameter corrections allow adjustment to the particular joint.

Pulse and Dual Pulse capability

Pulsed MIG/MAG modes are useful where weld appearance and heat-input control matter, particularly with aluminium. Dual Pulse helps produce a regular weld surface, while the final result depends on the material, joint preparation and selected settings.

According to the manufacturer's manual, Cool Pulse activates automatically in single-pulse mode below a wire feed speed of 2.5 m/min. It provides lower heat input and does not apply to Dual Pulse mode.

Wire feeding and MIG/MAG control

• Built-in two-roll feeder accepting spools up to 5 kg and Ø200 mm.
• 0.8, 1.0 and 1.2 mm wire, with rollers, liner and gas matched to the material.
• Synergic control and manual parameter selection.
• 2T/4T torch modes and inductance adjustment for tuning arc characteristics.
• Polarity reversal supports suitable self-shielded flux-cored wire without an external shielding-gas supply.
• Supports a compatible Spool Gun, purchased separately.

MMA, TIG Lift and applications

MIG current ranges from 30 to 200 A; TIG and MMA range from 10 to 200 A. In MMA, Hot Start assists arc ignition, Arc Force helps control arc dynamics, and VRD reduces open-circuit voltage.

TIG DC Lift uses contact arc ignition with an additional TIG torch and suitable gas. This is not an AC TIG machine; use a suitably prepared MIG process for aluminium. Its 12 kg weight and 490 × 225 × 340 mm housing make it easier to move around the workshop.

Supplied equipment

• SPARTUS EasyMIG 217DP welder.
• SPARTUS MIG SPE 150 torch, 3 m.
• Electrode holder with 2 m cable.
• Work return cable with clamp, 1.5 m.
• 0.8/1.0 mm roller for steel wire.
• 1.0/1.2 mm roller for aluminium wire.
• Wire liners for steel and aluminium.
• Gas hose, 2 m.