ELLIENT TOOLS cylinder liner puller, 3 jaws, 60–160 mm (AT1976)

AT1976 is intended for extracting a cylinder liner from an engine block.

Select the puller for liner diameter, edge geometry and support location. Mechanical pulling helps control the extraction direction. Key details: Number of jaws: 3; Range: 60–160 mm.

Jaw engagement

Check that the jaws can engage the liner edge correctly. Diameter alone does not establish compatibility with a particular block.

Support and pulling direction

Place supports only on suitable block areas under the repair procedure. Align the pulling axis with the liner axis.

Liner removal

Apply load gradually while watching supports and jaws. If movement stops, identify the cause before continuing.